ULTRAGUARD E2C 80X

High Gloss Nano Coating Non-Stick to Dust

Product Description

ULTRAGUARD E2C 80X is a specially designed nano technology based two pack clear coats to achieve high gloss optimum scratch and stain resistance easy to clean coating. This non-stick coating is specially designed to use as clear top coat as a final protective layer to prevent any stain marks or graffiti. It is non-stick to dust and any other solid darts protecting the aesthetic look of the surfaces for long duration. The surface can easily be cleaned and maintained without using any harsh chemical cleaners. Permanent marker inks can easily be removed from its surface by simple wiping with cloth or tissue paper.

Area Of Application

  • Applicable for plastics like Polycarbonate, ABS, PMMA etc.
  • All types of residential, industrial and exhaust Fans
  • Home appliances
  • Equipment and Machineries
  • Industrial uses

Benefits & Advantages

  • Water and mud repellent
  • Easy to clean / self-cleaning
  • No stain, completely wipeable
  • Anti-graffiti
  • Saves water for washing and cleaning
  • Reduced maintenance cost

 

  • Resistance against chemical cleaners
  • Long performance life
  • Can be applied by conventional spray process
  • Curing temperature and time: @ 80°C for 30 minutes
  • Recommended film thickness: 20-30 µm

Application Guideline

Surface Preparation:
  • The surface must be cleaned thoroughly from deposits like finger prints, dust & debris, release and slip agents or any other foreign materials.
  • Remove dirt, grease, oil and other contaminants by IPA (isopropyl alcohol) wiping
  • On Plastic surface area, apply especially E2C 80X Primer and allow it dry 10 to 15 minutes at room temperature before applying final top coat ULTRAGUARD E2C 80X.
Application:
  • Apply E2C 80X Primer on the plastic part and keep it 10 to15 minutes for flash off.
  • Mix 3 parts of part A with 1 parts of part B (by volume) of ULTRAGUARD E2C 80X
  • Mix for 5 minutes to obtain a homogeneous clear solution and allow to settle it for 10 minutes for maturation
  • Apply the mixed solution on the substrate using conventional spray process
  • Cured at 80 ºC for 30 minutes
  • Mixed solution should be used within 60-90 minutes after mixing
Precautions:
  • Check the thermal stability of plastic component prior to curing
  • Don’t apply materials below dew point and above 50°C.
  • Once base is mixed with hardener, paint should be consumed within pot-life.
  • Pot life may vary with temperature and humidity
  • Clean all tools with thinner immediately after application
  • Avoid application of excessive film thicknesses

Product Shelf life: 12 months from date of manufacturing